Chuck That's the same problem I have with my 4000 st+ unit...I think my problem is with the control head...the motor works fine when I aplly 12 V source but the controller sends no voltage to the motor...I found the service manual for the unit here; http://www.ganssle.com/jack/st4000.pdf and have concluded that a circuit component must have gone bad...mine will have to go to our local Raymarine service center
Dwight Veinot C&C 35 MKII, *Alianna* Head of St. Margaret's Bay, NS [email protected] On Sun, Jul 19, 2015 at 11:11 PM, Chuck S via CnC-List < [email protected]> wrote: > Seems my Raymarine 4000STPlus has a problem. It does not work. The > display is displaying and all buttons seem to work. Today it kept > displaying XTE. I pulled the motor connection and read a short pulse of > volts at the socket when I tried to change course through the controller. > The motor surged for a while and stopped. It seems like the motor is OK. > The display reads a magnetic heading and seems to function OK, but when I > push AUTO and change heading, nothing changes except the display heading. > > Wiring problem? I have a wired remote that may be lying under a pile of > sails, or a tool bag. Could that be causing interferance? > > Chuck > Resolute > 1990 C&C 34R > Broad Creek, Magothy River, Md > > _______________________________________________ > > Email address: > [email protected] > To change your list preferences, including unsubscribing -- go to the > bottom of page at: > http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com > > >
_______________________________________________ Email address: [email protected] To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
