Thanks Jack, I'll check outputs from the control head. Might be a connection or a wire between the control head and drive motor?
Chuck Resolute 1990 C&C 34R Broad Creek, Magothy River, Md ----- Original Message ----- From: "Jack Brennan via CnC-List" <[email protected]> To: [email protected] Cc: "Jack Brennan" <[email protected]> Sent: Sunday, July 19, 2015 10:42:11 PM Subject: Re: Stus-List Raymarine Autohelm problem Here’s a link to the repair manual for the 4000+: http://www.bristolsailboats.org/wp-content/uploads/2014/08/st40001.pdf If the motor works, the problem is probably inside the wheel, either the gear or the belt. It’s easy to take apart and investigate. Jack Brennan Former C&C 25 Shanachie, 1974 Bristol 30 Tierra Verde, Fl. From: Chuck S via CnC-List Sent: Sunday, July 19, 2015 10:11 PM To: cnc-list-bounces cnc-list ; CNC boat owners, cnc-list Cc: Chuck S Subject: Stus-List Raymarine Autohelm problem Seems my Raymarine 4000STPlus has a problem. It does not work. The display is displaying and all buttons seem to work. Today it kept displaying XTE. I pulled the motor connection and read a short pulse of volts at the socket when I tried to change course through the controller. The motor surged for a while and stopped. It seems like the motor is OK. The display reads a magnetic heading and seems to function OK, but when I push AUTO and change heading, nothing changes except the display heading. Wiring problem? I have a wired remote that may be lying under a pile of sails, or a tool bag. Could that be causing interferance? Chuck Resolute 1990 C&C 34R Broad Creek, Magothy River, Md _______________________________________________ Email address: [email protected] To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com This email has been checked for viruses by Avast antivirus software. www.avast.com _______________________________________________ Email address: [email protected] To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
_______________________________________________ Email address: [email protected] To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
