Not paying attention this past Monday I hit the piling at the fuel dock with
the stanchion on the starboard side that is used as part of the gate. The
stanchion was not damaged, the stainless steel support was bent and I am trying
to figure out if I should try bending it back or replace it. The tube is 2'
long, 1/2" outside diamater, and 3/8" inside diamater. Also, the cast aluminum
bracket that holds the stanchion to the toe rail is cracked.
Any suggestions where either piece can be located ?
Tom Vincent
Chesapeake City, MD
Frolic II is a 1979 C&C 36'.
_______________________________________________
Email address:
[email protected]
To change your list preferences, including unsubscribing -- go to the bottom of
page at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
