I made a puller using galvanized pipe flange of the appropriate size to slide over the shaft and sit against the prop. This is assuming shaft is out. If the shaft is not out, you could try to cut out a slot in the flange using angle grinder. With two galvanized flanges and appropriate length bolts you could have a 10$ puller.
Petar Horvatic Sundowner 76 C&C 38MkII On the hard at Stanleys in barrington From: CnC-List [mailto:[email protected]] On Behalf Of Hoyt, Mike via CnC-List Sent: Wednesday, March 22, 2017 8:48 AM To: [email protected] Cc: Hoyt, Mike Subject: Re: Stus-List Prop Pullers Randy It may be difficult to pull off even with pullers. On Persistence we tensioned the pullers to no avail. Then with pullers tensioned we applied heat to prop hub and once heated to our satisfaction tapped with a hammer. Note that we backed off the shaft nut quite a bit but left on the shaft to prevent prop from coming completely off before we were ready, Have been advised that sometimes prop comes off with a bit of force and can be dangerous. Others will elaborate Mike Persistence 1987 Frers 33 #16 Halifax, NS http://users.eastlink.ca/~mhoyt From: CnC-List [mailto:[email protected]] On Behalf Of Joel Aronson via CnC-List Sent: Wednesday, March 22, 2017 8:54 AM To: [email protected] Cc: Joel Aronson Subject: Re: Stus-List Prop Pullers A large gear puller should be enough. Joel On Wed, Mar 22, 2017 at 1:04 AM RANDY via CnC-List <[email protected]> wrote: Listers- What's your favorite prop puller? Or at least, which one / what kind would you recommend to pull a fixed two-blade 12" prop off a 7/8" SAE tapered shaft with 5/8" x 11 UNC thread? Thanks, Randy _______________________________________________ This list is supported by the generous donations of our members. If you wish to make a contribution to offset our costs, please go to: https://www.paypal.me/stumurray All Contributions are greatly appreciated! -- Joel 301 541 8551
_______________________________________________ This list is supported by the generous donations of our members. If you wish to make a contribution to offset our costs, please go to: https://www.paypal.me/stumurray All Contributions are greatly appreciated!
