Is there a valve manifold somewhere between the line and the pump? Have you tried closing the starboard valve or blowing through the port hose to see what happens?
Should not be hard to troubleshoot if you know where the lines run. On Mon, Mar 22, 2021 at 2:55 AM Peter McMinn via CnC-List < cnc-list@cnc-list.com> wrote: > I have a 30gal water tank under both settees. The valves for each are set > to open flow. However, the pump seems to draw only from the starboard side. > I’d assumed that with both valves open, the tanks would equalize, but the > stbd tank empties and the pump goes dry, while the port tank remains full. > Can someone venture to what’s going on? I’ve read this 2015 discussion > <https://cnc-list.com/empathy/thread/2KB2NSDGELMQQJSRMPPWPHVMCWQJ2ICR?hash=SLQZNGDWP5TUBYWW6HFGKHJT5DVCWB5F#SLQZNGDWP5TUBYWW6HFGKHJT5DVCWB5F>, > but the OP then was interested in disconnecting the two tanks. I’ll do some > exploring tomorrow to see what might be preventing the tanks from > equalizing. Ideas are welcome. > Thanks to all of the subscribers that contributed to the list to help with > the costs involved. If you want to show your support to the list - use > PayPal to send contribution -- https://www.paypal.me/stumurray Thanks > - Stu -- Joel
Thanks to all of the subscribers that contributed to the list to help with the costs involved. If you want to show your support to the list - use PayPal to send contribution -- https://www.paypal.me/stumurray Thanks - Stu
