Ron, do you have any photos of your setup? Thanks
Richard
Richard N. Bush Law Offices
2950 Breckenridge Lane, Suite Nine
Louisville, Kentucky 40220-1462
502-584-7255
-----Original Message-----
From: RON CASCIATO via CnC-List <[email protected]>
To: Stus-List <[email protected]>
Cc: RON CASCIATO <[email protected]>
Sent: Mon, Nov 22, 2021 10:22 pm
Subject: Stus-List Re: Garboard
Agreed, we did this on Impromptu almost 7-8 years ago. We drilled the hole a
quarter inch below the floor of the bilge...FROM THE OUTSIDE!!!I think the
diameter of the threaded piece is 1", I took it to Home Depot and found a male
adapter that fit....and pieced a 6" piece of PVC with a 45 degree angled
end....Bilge drains dry and no water running down the keel.The drain unscrews
out and the plug sits just under the hull surface.....we swipe it with a dollop
of Bondo and bottom paint.End of season, we just pick out the 1" circle of
Bondo and screw the PVC drain back in.An easy DYI project....Ron Casciato
ImpromptuC&C 38 MKII..'77
On Nov 22, 2021 4:50 PM, WILLIAM WALKER via CnC-List <[email protected]>
wrote:
Finally Did this 2 years ago..best thing ever did for the boat. Look in
archives, there is recent thread with good ideas Bill Walker
On Monday, November 22, 2021, 09:26:16 AM EST, Tom Sancton via CnC-List
<[email protected]> wrote:
Looking at putting a garboard on my 35 mark 3. Has anyone done this? Looking at
leaving my mast up but concerned about water entering the boat through the mast
Thanks to all of the subscribers that contributed to the list to help with the
costs involved. If you want to show your support to the list - use PayPal to
send contribution -- https://www.paypal.me/stumurray Thanks - StuThanks to all of the subscribers that contributed to the list to help with the
costs involved. If you want to show your support to the list - use PayPal to
send contribution -- https://www.paypal.me/stumurray Thanks - Stu
