> /etc/sysconfig/dhcpd
# Command line options here
DHCPDARGS=
>your ifconfig printout
[root@cobbler sysconfig]# ifconfig
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:20670 errors:0 dropped:0 overruns:0 frame:0
TX packets:20670 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:2331576 (2.2 MiB) TX bytes:2331576 (2.2 MiB)
venet0 Link encap:UNSPEC HWaddr
00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00
inet addr:127.0.0.1 P-t-P:127.0.0.1 Bcast:0.0.0.0
Mask:255.255.255.255
UP BROADCAST POINTOPOINT RUNNING NOARP MTU:1500 Metric:1
RX packets:18501 errors:0 dropped:0 overruns:0 frame:0
TX packets:15557 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:1913257 (1.8 MiB) TX bytes:3754172 (3.5 MiB)
venet0:0 Link encap:UNSPEC HWaddr
00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00
inet addr:212.72.124.87 P-t-P:212.72.124.87
Bcast:212.72.124.87 Mask:255.255.255.255
UP BROADCAST POINTOPOINT RUNNING NOARP MTU:1500 Metric:1
=======
(NOTE: The IP has been changed from actual output.)
I believe instead of "lo" there should be an "eth1" -- can see that
this is the case for the *old* Cobbler VPS that I migrated to OpenVZ,
where dhcpd runs but where there is another problem.
Frank
_______________________________________________
cobbler mailing list
[email protected]
https://fedorahosted.org/mailman/listinfo/cobbler
