did you try so set the glamo_mci.sd_max_clk, acording to: http://docs.openmoko.org/trac/ticket/1743 ?
Kind regards, Ed On Tue, 2008-12-30 at 14:17 +0000, Ruben Leote Mendes wrote: > Em Sab, Dezembro 27, 2008 04:06, Kosa escreveu: > > I've been trying to boot 2008.12 from a microsd but it just can't. > > It starts booting but then it stops with an "Only GTA01 hardware > > supported by ASoc driver" message. > > Happens to me also, but after that message I also have the following > messages (not sure if they change from boot to boot): > > Unknown HZ value! (87) Assume 100. > mount: special device /dev/mmcblkp01 does not exist > ALSA: restoring mixer settings... > Configuring network interfaces... /usr/sbin/alsactl: load_state:1327: No > soundcards found... > ADDRCONF(NETDEV_UP): usb0: link is not ready > done. > > I can shutdown by holding the power button. > I have FDOM in the same card and it works fine. > > Any clues? > _______________________________________________ Openmoko community mailing list [email protected] http://lists.openmoko.org/mailman/listinfo/community
