Don't know if this is expected behaviour, but when I moved "rw" part before all other kernel parameters:
r...@om-gta02:~# cat /boot/append-GTA02 rw console=tty0 loglevel=8 rootdelay=1 now Neo boots fine with Qi and finally shows Illume desktop and everything. 2009/1/4 Evgeny Karyakin <anthropophag...@gmail.com>: > 2008/12/30 Andy Green <a...@openmoko.com>: >> Somebody in the thread at some point said: >> | Em Sab, Dezembro 27, 2008 04:06, Kosa escreveu: >> |> I've been trying to boot 2008.12 from a microsd but it just can't. >> |> It starts booting but then it stops with an "Only GTA01 hardware >> |> supported by ASoc driver" message. >> | >> | Happens to me also, but after that message I also have the following >> | messages (not sure if they change from boot to boot): >> | >> | Unknown HZ value! (87) Assume 100. >> | mount: special device /dev/mmcblkp01 does not exist >> | ALSA: restoring mixer settings... >> | Configuring network interfaces... /usr/sbin/alsactl: load_state:1327: No >> | soundcards found... >> | ADDRCONF(NETDEV_UP): usb0: link is not ready >> | done. >> | >> | I can shutdown by holding the power button. >> | I have FDOM in the same card and it works fine. >> >> I was just meddling with this in NAND, I believe that "ro" on the kernel >> commandline is fatal for startup of 2008.12. When I removed it from Qi, >> 2008.08 started up OK. >> >> So check your U-Boot env if you're using that for "ro", or try adding rw >> to /boot/append-GTA02 if you are on SD Card and Qi. >> >> It's pretty common to boot with rootfs ro initially... > > I have these problems also, and adding "rw" to append-GTA02 didn't > solve it. Full content of my /boot/append-GTA02 is this: "console=tty0 > loglevel=8 rootdelay=1 rw" (brainless copy-paste of everything related > from Qi wiki page[1]). _______________________________________________ Openmoko community mailing list community@lists.openmoko.org http://lists.openmoko.org/mailman/listinfo/community