on 11/6/03 5:01 PM, Chris "Zap" at [EMAIL PROTECTED] wrote: > The voltage output has been rechecked and I now have proper voltages. I > pulled up all of the caps in the Power Supply and replaced them. Two of > them actually had leads fall out, so I believe those were the bad ones. The > computer gives a startup bong. From there, the computer's top half of the > screen appeared, and so I replaced Q1 and the resistors R2,R3 which had > burned up (according to Dead Mac Scrolls). I also went ahead and replaced: > Q2, Q5, and CR15 according to two other sections. Now the machine gives the > bong, and on the screen is a bunch of lines, which are spaced just a bit, > but get closer together and then finally a bright white line in the center > of the screen. What should I check/replace or adjust now? I can't believe > the thing actually is working this well!! Hopefully I can get it fully > working again! > > -Chris
Go back to the Scrools. There's a section on screen anomalies. You have some more parts to replace, but you're mighty close. Jeff -- Compact Macs is sponsored by <http://lowendmac.com/>. Support Low End Mac <http://lowendmac.com/lists/support.html> Compact Macs list info: <http://lowendmac.com/lists/compact.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive:<http://www.mail-archive.com/compact.macs%40mail.maclaunch.com/> --------------------------------------------------------------- >The Think Different Store http://www.ThinkDifferentStore.com ---------------------------------------------------------------
