On Thu, 9 Oct 2003, Gamba wrote: > This is usually a cold solder joint on connector P5 on the analog card. > As it gets worse it overheats more and more, and eventually the heat can > cause corrosion on the mating pin in the harness, and that's a lot more > trouble to fix.
Gamba, I have my SE/30 open at the moment, and looked at this connector - it goes from the analog board to the hard drive, not to the monitor - did you mean P2, which goes to the little card at the end of the video tube? Thanks, Jacob -- Reality is that which, when you stop believing in it, doesn't go away. -- Philip K. Dick -- Compact Macs is sponsored by <http://lowendmac.com/>. Support Low End Mac <http://lowendmac.com/lists/support.html> Compact Macs list info: <http://lowendmac.com/lists/compact.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive:<http://www.mail-archive.com/compact.macs%40mail.maclaunch.com/> --------------------------------------------------------------- >The Think Different Store http://www.ThinkDifferentStore.com ---------------------------------------------------------------
