Well at least you're getting the same behavior as the other machines of
that class =(. I think all you can do at this point is wait for the next
ISO's. I'm using a 2.4.4 kernel on those, which I hope will work on these
machines. I don't have access to one to test with.
Stew Benedict
--
MandrakeSoft OH/TN, USA http://perso.mandrakesoft.com/~sbenedict/
On Thu, 12 Jul 2001, Mike Browning wrote:
> i looked at the devalias and it said that the cd-rom is set for drive 0 and i had
>the jumper on the cd-rom set for slave i set the jumper to master and now the cd
>boots but now i get a kernel panic and the unit reboots?
> ----- Original Message -----
> From: Brice D Ruth
> To: [EMAIL PROTECTED]
> Sent: Thursday, July 12, 2001 9:03 PM
> Subject: Re: not booting
>
>
> Correct me if I'm wrong here, Stew -
>
> but you might try going into Open Firmware (start the computer, listen for the
>boing, hit option-command-O-F simultaneously) and type devalias to see what 'cd' is
>aliased to - write back on what it is. We may be able to detect something wrong.
>
> -Brice
>
> Mike Browning wrote:
>
> I just burned the iso image on a disk using EZ-CDR4 and tried to boot fromthe disk
>that was made is there anything special that i need to do?----- Original Message
>-----From: "Stew Benedict" <[EMAIL PROTECTED]>To:
><[EMAIL PROTECTED]>Sent: Thursday, July 12, 2001 8:14 PMSubject: Re: not
>booting
> That's a new one. We've had others with those machines that would get akernel panic
>at boot, but I don't think I've seen anyone with the probelmas you describe it. Is
>is possible that the burn was bad in some way?There should be new ISO's coming out
>pretty soon, with a new kernel andboot setup, which may solve your issues.Stew
>Benedict--MandrakeSoft OH/TN, USA http://perso.mandrakesoft.com/~sbenedict/On Thu, 12
>Jul 2001, Mike Browning wrote:
> its one of the first G3 blue&white 450Mhz the one that has the ABD portIDE hard
>drive and cdrom----- Original Message -----From: "Stew Benedict"
><[EMAIL PROTECTED]>To: <[EMAIL PROTECTED]>Sent: Thursday, July
>12, 2001 6:35 PMSubject: Re: not booting
> What kind of machine? Is the CD drive IDE or SCSI? It may be that
> the
> Open Firmware device is not "cd" on your machine.Stew Benedict--MandrakeSoft OH/TN,
>USA http://perso.mandrakesoft.com/~sbenedict/On Thu, 12 Jul 2001, Mike Browning wrote:
> I downloaded the iso and burned a cd from it. the cd will boot but
> when
> you try some thing like:
> boot: install-aty128fbit says:Loading kernel...Can't open device <cd:0>Image not
>found.... try againWARNING ! default_close called !boot:can anyone tell me what i'm
>doing wrong?thanksMike
>
>
>
>
>
>
>
