|
i looked at the devalias and it said that the
cd-rom is set for drive 0 and i had the jumper on the cd-rom set for slave
i set the jumper to master and now the cd boots but now i get a kernel panic and
the unit reboots?
----- Original Message -----
Sent: Thursday, July 12, 2001 9:03
PM
Subject: Re: not booting
Correct me if I'm wrong here, Stew -
but you might try
going into Open Firmware (start the computer, listen for the boing, hit
option-command-O-F simultaneously) and type devalias to see what 'cd' is
aliased to - write back on what it is. We may be able to detect
something wrong.
-Brice
Mike Browning wrote:
000701c10b3b$f0c5b7b0$[EMAIL PROTECTED] type="cite">I just burned the iso image on a disk using EZ-CDR4 and tried to boot from
the disk that was made is there anything special that i need to do?
----- Original Message -----
From: "Stew Benedict" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Thursday, July 12, 2001 8:14 PM
Subject: Re: not booting
That's a new one. We've had others with those machines that would get a
kernel panic at boot, but I don't think I've seen anyone with the probelm
as you describe it. Is is possible that the burn was bad in some way?
There should be new ISO's coming out pretty soon, with a new kernel and
boot setup, which may solve your issues.
Stew Benedict
--
MandrakeSoft OH/TN, USA http://perso.mandrakesoft.com/~sbenedict/
On Thu, 12 Jul 2001, Mike Browning wrote:
its one of the first G3 blue&white 450Mhz the one that has the ABD port
IDE hard drive and cdrom
----- Original Message -----
From: "Stew Benedict" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Thursday, July 12, 2001 6:35 PM
Subject: Re: not booting
What kind of machine? Is the CD drive IDE or SCSI? It may be that
the
Open Firmware device is not "cd" on your machine.
Stew Benedict
--
MandrakeSoft OH/TN, USA http://perso.mandrakesoft.com/~sbenedict/
On Thu, 12 Jul 2001, Mike Browning wrote:
I downloaded the iso and burned a cd from it. the cd will boot but
when
you try some thing like:
boot: install-aty128fb
it says:
Loading kernel...
Can't open device <cd:0>
Image not found.... try again
WARNING ! default_close called !
boot:
can anyone tell me what i'm doing wrong?
thanks
Mike
|
