----- Original Message ----- From: "Vincent Danen" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Saturday, September 28, 2002 12:18 PM Subject: Re: iMac266, OSX Man82ppc installation won't boot
On Saturday, September 28, 2002, at 08:17 AM, Damon Garn wrote: > I've just attempted a Mandrake 8.2ppc install on my iMac266, which is > already running MacOSX. The expert install sequence appeared to > succeed correctly (it even reported a successful install). Upon reboot > I get only a grey screen - no boot loader prompt. The machine sits > idle from that point, forcing a manual restart. This is yaboot not working properly most likely. > Attempted the following: > 1. suggested fix of cmd-opt-o-f and set the OF option to the > designated partition (*) with 'setenv boot-device hd:8;\\tbxi' then > 'shut-down' What is /dev/hda8 (ie. what partition is this? /boot? the apple bootstrap?) [This was the designated partition identified by the M8.2 install as the "blessed partition" where the normal startup would go to look for the boot manager (as I understand the process). The expert mode setup said to write that partition number down and use the above process in case of a failed boot. The OSX partitions are previous to that and the 3 Linux partitions I created follow it. ] > 2. followed the documentation suggestion of resetting the pram with > cmd-opt-p-r and that allows a successful OSX boot. Apple's Disk > Utility continues to show the two 7.8GB OSX partitions I had as well > as a greyed-out "bootstrap" partition (I suspect this to be the > "blessed partition"). No Linux partitions show (is it normal for them > not to show?). I requested /boot at 45MB, / at 10GB, /swap at 400MB > and it claimed to be building them. I requested ext3 for the / > partition, if it matters. No, OS X will not show the Linux partitions. Unfortunately. =) > 3. Subscribed to this list. :) Good move... =) > No funky hardware - all is stock except for the larger hard drive I > installed a year or so ago, which I had left with free space so I > could try this very thing. My mind is fuzzy, so I'm probably not too much help, but if you can provide the details of /dev/hda8 that'd be great. [See above - designated by Mandrake installer as location of boot manager.] The other option might be to boot off the 8.2 install CD into rescue mode, then chroot your root partition (usually automatically mounted in /mnt, so do "chroot /mnt") and check your /etc/yaboot.conf file to make sure it looks ok. Also try running "ybin -v" to regenerate the bootstrap stuff. The other option, that I've encountered on my newer G4 imac, is I've had to power down the imac after getting it stalling like you describe, but on the next power up yaboot always comes up fine. So for me it's just a nuisance. -- MandrakeSoft Security; http://www.mandrakesecure.net/ "lynx - source http://linsec.ca/vdanen.asc | gpg --import" {FE6F2AFD: 88D8 0D23 8D4B 3407 5BD7 66F9 2043 D0E5 FE6F 2AFD}
