Rob, you can buy replacement brake pucks direct through Goodyear. They carry the same number as in the Univair catalog except that they now have a "-2" at the end. I called Univair and they gave me the number for the regional Goodyear dealer in their area. The salesman at Goodyear put the number in the computer and had me four pucks in 15 seconds. They came from a warehouse in Texas. Price was $37.35 each. Considering that I was paying list price for them, I did not think that I was doing too bad. It turns out that my problem was in the master cylinder, so I still have a complete set of four new pucks. And it is a little tough finding used Clevelands for the Ercoupe. I found a set that came off a Coupe that crashed this spring 15 miles from the airport. They cost me $500 after having everything checked for cracks. I will be installing them at my next annual in the spring. Dennis Schmaltz N94715
[EMAIL PROTECTED] wrote: > > Hi Coupers. Thanks for the replys to my question regarding the Fin Leading > Edges. It turns out that Univair sells an "untrimmed" LE that is shaped to fit > but requires trimming to final size. The part number is 23010-b @ 27.49 each. > I am told it takes about 1/2hr to trim and install each of them. This price I > can live with. > > I am still in the market for a used set of Cleveland brakes/hubs. Its getting > to the point that I don't want to land on anything shorter than a 4,000 footer > :-( The old Goodyears hold just enough for runup but I don't know long they > will last for even this. $750 -800 is a bit steep for my pocket with Xmas just > around the corner. I welcome any suggestions. Thanks, Rob
<<attachment: winmail.dat>>
