I use a solid steel boldt (found at most hardware stores) that works very well just make sure you get it long enough so that it sticks out far enough to be able to get your lifting mechanism under it.
BE CAREFULL THINK THIS THRU BEFORE DOING IT IT COULD TURN OUT TO BE VERY EXPENSIVE IF NOT DONE CORRECTLY Jim Palmer In a message dated 7/12/00 5:15:05 AM Pacific Daylight Time, [EMAIL PROTECTED] writes: << 1. The bar through the knee joint to use for jacking up the plane -- when I replaced mine, I used a pipe that wasn't strong enough. It worked, but it bent. Try looking for a solid bar or pipe with very thick side walls with the outside diameter that will fit through that opening in the gear knee joint, then keep it for future work. >> __________________________________________________________________________ ______ To unsubscribe from this list please send mailto:[EMAIL PROTECTED] ___________________________________________________________ T O P I C A The Email You Want. http://www.topica.com/t/16 Newsletters, Tips and Discussions on Your Favorite Topics
<<attachment: winmail.dat>>
