You may need to change the switch position of SW3-4
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On
Behalf Of [EMAIL PROTECTED]
Sent: Tuesday, September 26, 2006 2:47 AM
To: [email protected]
Subject: Problem with demos in DVEVM 1.10 update
Hello -
I've just upgraded my DVEVM board to "1.10" by using the
"restore_1_10_00_30.tar" file to wipe/replace everything on the DVEVM
hard drive. I separately replaced the "uImage" in flash with the one
included in that .tar file.
Everything boots OK. I don't get error messages from cmemk during boot
(I was getting this when I was running the old kernel but booting from
the new hard drive - they went away when I upgraded the uImage to
match).
Whenever I start a demo using the remote ("decode", for example), it
just 'hangs'. Running "top" shows the "decode" demo at the top, taking
about 95% of CPU time.
I followed the instructions for running demos on the command line, and
get similar results. For example, from the "/opt/dvevm" directory, I
typed:
./loadmodules.sh (gives warnings about modules already being loaded)
./decode -v data/videos/davincieffect_ntsc.m2v -a
data/sounds/davincieffect.mp2
The demo shows "Decode demo started." immediately (but nothing appears
on video output).
After about 30 seconds to 1 minute, I get the following message at the
console:
TraceUtil> Error: Failed to open codec engine "decode"
I get similar results running other demos.
Does anyone have any idea what is going wrong?
Thanks,
- Paul
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
