It is the same "failed to open Engine error" for decode demo. This is only happen when I update to DVEVM 1.10 release (I believe I did a clean update). BTW, What is SW304 switch to On position requirement? I never did check this switch thing for my current DVEVM 1.0 release and it works fine before. thanks,
alan --- "Monk, Roger" <[EMAIL PROTECTED]> wrote: > Did you check that SW3-4 is in the "on" position? > > Is the decode only demo working ok? > > ~roger > > -----Original Message----- > From: > [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] > On > Behalf Of Alan Li > Sent: 28 September 2006 23:21 > To: [email protected] > Subject: DVEVM 1.10 Encode Demo > > Hi, > > I upgraded to DVEVM 1.10 release. I believe i did a > clean upgrade and use the coming uImage to do a TFTP > boot. Once I compiled the all the demo codes and > launch the encode or encodedecode demo, it always > fails to open the engine (Engine_open call) failed. > Does anyone have similar problem or any suggestion? > thanks, > > alan > _______________________________________________ > Davinci-linux-open-source mailing list > [email protected] > http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source > _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
