Thx guys, I'm trying these options next. Stan
--- On Tue, 8/5/08, Jon Povey <[EMAIL PROTECTED]> wrote: From: Jon Povey <[EMAIL PROTECTED]> Subject: RE: DM6467 + GPIO To: [email protected] Date: Tuesday, August 5, 2008, 11:58 PM > depending on how daring you are, you could just solder two > wires to the PCB and forget about the connector + expansion > board. We did that on an EVM where we ordered the wrong > connector and had to hurry. Agreed, don't bother making up a proper board and so on. I have had much success with such advanced rapid prototyping techniques as: - Jamming wire into connector sockets - Lifting unhelpful pins of EVM components - Tacking extra connections between legs of EVM chips Etc, etc. -- Jon Povey, Design Engineer [EMAIL PROTECTED] | +44(0)1280 825983 Racelogic is a limited company registered in England. Registered number 2743719 . Registered Office Unit 10, Swan Business Centre, Osier Way, Buckingham, Bucks, MK18 1TB . The information contained in this electronic mail transmission is intended by Racelogic Ltd for the use of the named individual or entity to which it is directed and may contain information that is confidential or privileged. If you have received this electronic mail transmission in error, please delete it from your system without copying or forwarding it, and notify the sender of the error by reply email so that the sender's address records can be corrected. The views expressed by the sender of this communication do not necessarily represent those of Racelogic Ltd. Please note that Racelogic reserves the right to monitor e-mail communications passing through its network _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
_______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
