Thanks a lot steve.. after disabling EABI in my kernel config I could able to boot the board..
Thanks a lot again.. Manjunath.AM -----Original Message----- From: Steve Chen [mailto:[email protected]] Sent: Tuesday, April 28, 2009 6:23 PM To: [email protected] Cc: [email protected] Subject: RE: Changing Machine ID On Tue, 2009-04-28 at 18:10 +0530, Manjunatha AM wrote: > Hi Steve, > > Thanks for your reply.. > > I checked in /dev/console and it is present. I am using nfs file system > only...facing this problem while mounting nfs filesystem only... > > With the same setup and bootargs,I could boot the device properly with > 2.6.10 kernel image but problem is only with 2.6.28 and hence i cant suspect > on filesys.. > > Is there /sbin/Init is not getting proper support for 2.6.28 kernel since > the filesys used is bit old version??? One of Caglar's suggestions is disable EABI in the kernel config and re-compile the kernel. It worked for last poster. Perhaps you want to try it as well. Regards, Steve The information contained in this electronic message and any attachments to this message are intended for the exclusive use of the addressee(s) and may contain proprietary, confidential or privileged information. If you are not the intended recipient, you should not disseminate, distribute or copy this e-mail. Please notify the sender immediately and destroy all copies of this message and any attachments contained in it. _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
