On Thu, 2009-05-14 at 13:49 +0800, zuowenping wrote: > My develop envirment : > DaVinciLSP_02_00_00_110 ,mvltools5_0_0801921 and dm355 evm > I have built the kernel by reference the pdf " TMS320DM355 DVEVM v1.30 > Getting Started Guide" , > DM355 EVM # printenv > bootdelay=3 > baudrate=115200 > bootfile=uImage > bootcmd=nboot 0x80700000 0 0x400000;bootm 0x80700000 > fileaddr=80700000 > ipaddr=10.0.0.53 > bootargs=console=ttyS0,115200n8 noinitrd rw ip=dhcp root=/dev/nfs > nfsroot=10.0.0.89:/nfs/restore_dm355,nolock mem=116M > video=davincifb:vid0=720x576x16,2500K:vid1=720x576x16, > 2500K:osd0=720x576x16,2025K davinci_enc_mngr.ch0_output=COMPOSITE > davinci_enc_mngr.ch0_mode=pal > serverip=10.0.0.89 > filesize=2191c0 > stdin=serial > stdout=serial > stderr=serial > videostd=pal > > Environment size: 491/16380 bytes > why not success? > Any clues will be appreciated!
Just want to make sure I understand, you can boot the board with the binary that comes with DVSDK, but you can not boot the board with the binary generated by following the "Getting Started Guide" If that is the case, what are the commands you used to configure and build the kernel and what error did you see during boot up? Regards, Steve _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
