Dear zuowenping do make menuconfig
Enable kernel hacking->kernel debuging->low level debug functions and compile the kernel and post the kernel output here Regards Deepak On 5/14/09, Steve Chen <[email protected]> wrote: > > On Thu, 2009-05-14 at 13:49 +0800, zuowenping wrote: > > My develop envirment : > > DaVinciLSP_02_00_00_110 ,mvltools5_0_0801921 and dm355 evm > > I have built the kernel by reference the pdf " TMS320DM355 DVEVM v1.30 > > Getting Started Guide" , > > DM355 EVM # printenv > > bootdelay=3 > > baudrate=115200 > > bootfile=uImage > > bootcmd=nboot 0x80700000 0 0x400000;bootm 0x80700000 > > fileaddr=80700000 > > ipaddr=10.0.0.53 > > bootargs=console=ttyS0,115200n8 noinitrd rw ip=dhcp root=/dev/nfs > nfsroot=10.0.0.89:/nfs/restore_dm355,nolock mem=116M > video=davincifb:vid0=720x576x16,2500K:vid1=720x576x16, > 2500K:osd0=720x576x16,2025K davinci_enc_mngr.ch0_output=COMPOSITE > davinci_enc_mngr.ch0_mode=pal > > serverip=10.0.0.89 > > filesize=2191c0 > > stdin=serial > > stdout=serial > > stderr=serial > > videostd=pal > > > > Environment size: 491/16380 bytes > > why not success? > > Any clues will be appreciated! > > > Just want to make sure I understand, you can boot the board with the > binary that comes with DVSDK, but you can not boot the board with the > binary generated by following the "Getting Started Guide" > > If that is the case, what are the commands you used to configure and > build the kernel and what error did you see during boot up? > > > Regards, > > Steve > > > > _______________________________________________ > Davinci-linux-open-source mailing list > [email protected] > http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source >
_______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
