On Wed, Sep 16, 2009 at 12:22 PM, Nori, Sekhar <[email protected]> wrote: > On Wed, Sep 16, 2009 at 12:11:19, Viral Sachde wrote: >> On Tue, Sep 15, 2009 at 8:24 PM, Nori, Sekhar <[email protected]> wrote: >> > Hi Viral, >> > >> > On Tue, Sep 15, 2009 at 19:06:55, Viral Sachde wrote: >> >> On Tue, Sep 15, 2009 at 5:58 PM, <[email protected]> wrote: >> >> > Hi, >> >> > >> >> > Here you don't need to create the nodes in /dev dir, as they are >> >> > created on >> >> > the boot-up time. >> >> > Make sure that your configuration in kernel for the console is correct. >> >> > And >> >> > make sure that the file-system your using is not a corrupted one. >> >> > >> >> > Regards, >> >> > Venkatesh >> >> >> >> Hi Venkatesh, >> >> >> >> I have used defconfig of davinci for kernel configuration. >> > >> > What is the full build step? >> > >> > I do something like: >> > >> > make distclean davinci_all_defconfig uImage ARCH=arm CROSS_COMPILE=<path >> > to CodeSourcery 2009q1 toolchain> >> > >> >> File system is NFS based and working well with previous versions of >> >> kernel. >> > >> > Within TI we are using filesystem from arago project[1] for testing. >> > >> > Can you pick up the one of the latest versions and see if you are able to >> > boot-up? >> > >> > Also, DaVinci git is now based on 2.6.31, you can rebase before retrying. >> > >> > Thanks, >> > Sekhar >> > >> > [1] http://arago-project.org/files/releases/ >> > >> > >> >> >> Hi Sekhar & all, >> >> Thanks for directions. I am now able to boot 2.6.31 compiled with >> codesourcery tool chain and arago filesys. >> >> Couple of things: >> 1. In codesourcery tool chain mkimage tool is not available. > > Hi Viral, > > This is a part of U-Boot; it gets built when you build U-Boot. > >> 2. In arago project page, lot of release are available, but none >> marked as latest-stable. > > The ones marked -rcX are release candidates, rest are released versions. > You can pick up the latest released version. > > Thanks, > Sekhar > >> >> Regards, Viral
Hi all, With recent 2.6.31, After configuring AIC audio codec and USB as hub with few more usb drivers selected, such as serial, mass storage, I re-compiled kernel. It is not able to detect AIC33 and USB Hub. Any suggestions are well come. With LSP 1.30, it was working fine. I have attached boot log and kernel config for 2.6.31. Regards, Viral _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
