Package: installation-reports Version: report for HP ProLiant DL380 Severity: important
INSTALL REPORT Debian-installer-version: daily CD image 20040217 uname -a: Date: 2004-feb-18 12:00 CET Method: netinst CD image Machine: HP ProLiant DL380 Processor: 1 Xeon 2.80Ghz Memory: 1,5Gb Root Device: Root Size/partition table: Output of lspci: Base System Installation Checklist: Initial boot worked: [O] Configure network HW: [O] Config network: [E] Detect CD: [O] Load installer modules: [O] Detect hard drives: [O] Partition hard drives: [O] Create file systems: [E] Mount partitions: [ ] Install base system: [ ] Install boot loader: [ ] Reboot: [ ] [O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it Comments/Problems: The DHCP configuration didn't work: it was giving an error in tty1 while the log in tty4 was showing with DHCPDISCOVER/DHCPOFFER/DHCPREQUEST/DHCPACK and then the last line with 'bound to 192.168....'. Even ifconfig was showing the correct state. I had to remove the config (ifconfig eth0 down) and then use the manual configuration. After partitioning the hard drives I wasn't able to create a file system on them since the list of partitions was like this: --------------------------- d 47,8 MiB n/a Finish Cancel --------------------------- (I created one partition for / (1Gb) and one for swap (50Mb)) I then went to partman and selected the partition for format. Partman was able to format them but then I couldn't mount it for installing the base system. I then tried to use LVM: I partitioned the hard disks, marked partition for LVM, create VG and all LV, then partman showed the LV as disks instead of partitions and prompted me to create a partition table on it. -- System Information: Debian Release: testing/unstable Architecture: i386 Kernel: Linux casa 2.4.24 #2 SMP dom feb 15 09:39:52 CET 2004 i686 Locale: LANG=C, LC_CTYPE=C -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
