Package: installation-reports Debian-installer-version: 2004-05-14 ftp.de.debian.org/debian/dists/sarge/main/installer-i386/current/images/hd-media/boot.img.gz uname -a: n/a Date: 2004-05-14 Method: usb-stick SIEMENS FIREBIRD USB2 (correcty detected by debian-installer decompressed boot.img.gz onto /dev/sda and copied sarge-i386-netinst.iso (2004-05-13) Machine: IBM Thinkpad t40p Processor: Pentium M 1,6 GHz Memory: 512 MB Root Device: IDE
root device not yet setup (I wanted to do that during installation) hard disk: IC25N080ATMR04-0 (IBM/Hitachi 80 GB) partitions /dev/hda1 ntfs approx. 7,9 GB /dev/hda2 nfts approx. 800 MB /dev/hda3 vfat approx 2GB rest is unallocated and reserved for debian Output of lspci: - Base System Installation Checklist: Initial boot worked: [E] Configure network HW: [ ] Config network: [ ] Detect CD: [ ] Load installer modules: [ ] Detect hard drives: [ ] Partition hard drives: [ ] Create file systems: [ ] Mount partitions: [ ] Install base system: [ ] Install boot loader: [ ] Reboot: [ ] [O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it Comments/Problems: installer started fine from usb-stick and installation proceeded until "Searching drinves for an installer ISO image. All modules were loaded just fine but then the installer says "Scanning /dev/discs/disc0/part3 (in My eBooks/) .." and stop at 30% scanning. It remains there for about 5-10 min and then starts the scanning again until the 30% stage. /var/log/messages reports the modules loaded (last entry: sd_mod) /var/log/syslog reports the following: ... user.notice hd-image-detect: Failed mounting /dev/discs/disc0/part2 syslog.warn klogd: VFS: Can't find ext2 filesystem on dev ide0(3,3) syslog.err klogd cramfs: wrong magic syslog.warn klogd: Unable to identify CD-ROM format. syslog.warn klogd: VFS: Can't find ext3 filesystem on dev ide0(3,3) syslog.warn klogd: sh-2021: reiserfs_read_super: ca not find reiserfs on ide0(3,3) user.notice hd.image-detect: Mounted /dev/discs/disc0/part3 for first pass The first message is presumable OK since there ist an ntfs on /dev/hda2. (Same message are also reported for /dev/hda1). The following messages also make sense, since there ist a vfat fs installed on /dev/hda3. However, the installation hangs on the final user.notice message Any help will be greatly appreciated. Jan Gl�scher -- Jan Gl�scher NeuroImage Nord Department of Neurology, Bldg S10 University Hospital Hamburg-Eppendorf Martinistr. 52 D-20246 Hamburg Germany Phone: +49-40-42803-7890 Fax: +49-40-42803-9955 Email: [EMAIL PROTECTED]
