Hi, On Tue, Nov 07, 2000 at 11:20:42PM -0500, Neal H Walfield wrote: > > I've fixed some typos etc: > > Thanks, they look good.
On a side note, I quote your document: --- quote --- GNU Mach labels IDE disks starting at zero as hdN, and SCSI disks as sdN. However, like Grub but unlike Linux, the drives are numbered in the order which they are found: i.e. not their position on the bus. This is to say that if the only IDE disk on the system is the secondary master, it is hd0. --- unquote --- However, the FAQ says something different (and I believe it is correct here): --- quote --- First, figure out the disk number. If it is a SCSI disk, you need to know the SCSI disk number. If it is an IDE disk, you need to know on which controller it is and if it is a master or slave. For Linux, the master disks on the primary controller has the letter "a", the slave on the same controller the letter `b'. Master and slave on the secondary controller have the letters `c' and `d' respectively. The Hurd does use BSD style notation so it is `0', `1', `2' and `3' instead `a', `b', `c' and `d'. This means /dev/hdc under Linux translates to /dev/hd2 under the Hurd. Got it? Good. GRUB does it differently! GRUB is doing it like the BIOS and enumerates all installed disks it can boot from starting from "0" incrementing by 1. So `hd(0,?)' is a partition on the first disk it can boot from, regardless if this is a master or slave or whatever. The second disk it finds has `hd(1,?)' etc. Luckily, the BIOS is searching in the well defined order primary controller master/slave, secondary controller master/slave. --- unquote --- Should this be changed in the installation guide? > Thanks, > -Neal > > -- > Neal H Walfield > University of Massachusetts at Lowell > [EMAIL PROTECTED] or [EMAIL PROTECTED] Thanks, -- Stefanus Du Toit sjdutoit at uwaterloo dot ca http://3.141593.org/ Please use GnuPG/PGP: http://3.141593.org/gpg/ ! NOTE: New key as of 2000-10-31. DO NOT USE 0x302577A9 anymore !
