Well I did as was suggested below and also by Declude.
 
However I used the directions below and put it into the declude.cfg file
 
WRONG!
 
It belongs in the global.cfg file.
 
I look forward to the time that the GUI is available for pre-existing setups
 
This has been quite a disruption and is so needless.
 
A GUI would take care of what we want done and would know where to put it and what syntax to use.
 
I sure hope a conversion for an existing setup will be built so that we can start using the GUI
 
Anyway.  It now works
 
Thank you all.
 

Harry Vanderzand
inTown Internet & Computer Services
519-741-1222

 


From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Kami Razvan
Sent: Friday, September 29, 2006 9:32 AM
To: [email protected]
Subject: RE: [Declude.JunkMail] Crisis after upgrade to 4.3.14 from 4.3.7

Harry..
 
In the upgrade there is a new feature that you can set in the .cfg file.
 
OUTBOUNDSCANNINGSPAM ON
INBOUNDSCANNINGSPAM ON
 
In declude.cfg add the following two lines and change the outbound to on.  The default in the example was off and if you are forwarding messages then that can cause the problem.  We ran into the same problem and discovered what was going on.
 
Regards,
Kami


From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Harry Vanderzand
Sent: Friday, September 29, 2006 9:15 AM
To: [email protected]
Subject: [Declude.JunkMail] Crisis after upgrade to 4.3.14 from 4.3.7

Last night at 8:11PM I upgraded from 4.3.7 to 4.3.14
 
From that point on we stopped catching all spam for these clients that have their own mail server.  We just filter their mail for spam and pass it on.
 
I just reverted back to 4.3.7 and now we are catching spam again for them
 
We catch over 4000 spam messages per day for one of these clients alone so you can imagine their complaint this morning.
 
Anyone know what would have caused this?
 
Thank you
 

Harry Vanderzand
inTown Internet & Computer Services
11 Belmont Ave. W., Kitchener, ON,N2M 1L2
519-741-1222

 

---
This E-mail came from the Declude.JunkMail mailing list. To
unsubscribe, just send an E-mail to [EMAIL PROTECTED], and
type "unsubscribe Declude.JunkMail". The archives can be found
at http://www.mail-archive.com.
---
This E-mail came from the Declude.JunkMail mailing list. To
unsubscribe, just send an E-mail to [EMAIL PROTECTED], and
type "unsubscribe Declude.JunkMail". The archives can be found
at http://www.mail-archive.com.

---
This E-mail came from the Declude.JunkMail mailing list. To
unsubscribe, just send an E-mail to [EMAIL PROTECTED], and
type "unsubscribe Declude.JunkMail". The archives can be found
at http://www.mail-archive.com.

Reply via email to