Hi all,
Thanks for the reply all of you.
I
have copied, from the CD, the INSTALL and RUNIMAGE directories onto my HD
(to a directory called c:\Delphi4).
Then I
ran SETUP.EXE located in the INSTALL directory. This setup procedure works
fine in principle, running through the interactive session (indicating that it is not a hardware related problem I
presume).
However it again failed the installation and
comes up with that same error message (as reprinted below).
The second error message (-113) talks
about specifying the drive letter. How am I suppose to specify the
drive letter? I run SETUP.EXE from the Start-Menu's RUN command:
"c:\Delphi4\Install\SETUP.EXE".
Has anybody any ideas how to solve this (urgent)
problem?
Note: I have re-installed Delphi 2 (from the CD) without
any problems.
Your help is highly appreciated.
John Christenhusz.
Error Message:
After the interactive session (asking: what, where,
serial# & authorization key, etc.) it starts copying files
and comes up (at 0%) with the following message:
Error copying
files.
Unknown error
Error code: -1
Source file:
*.cnf
Destination file: <nothing quoted
here>
Then when I continue, it comes up (at 8%) with
following message:
-113 error while copying
files.
Could not find "RunImage" directory.
...
Copy Install dir
& RunImage...
Must CD root mapped to a drive
letter.
Hereafter it gives up and the installation
process is terminated.
