Thanks, do you know exactly where that is? Is it Component > Install Packages, then un-tick all the 'ExpressSkins Library Uses Clause AutoFill Helper'?
Robo On Thu, Aug 23, 2012 at 5:13 PM, Jeremy North <[email protected]> wrote: > Make sure you don't have the 300 skins that come with devexpress included. > > There is an option in the IDE to disabled them for a project or for all > time. > > > On Thu, Aug 23, 2012 at 2:53 PM, Colin Johnsun <[email protected]> wrote: >> >> Delphi XE2 carries over a lot of meta information for use with the >> RTTI. This may be the cause of the bloat in size. >> >> There are compiler options which you can use to switch it off. See the >> link below: >> >> >> http://delphi.about.com/b/2011/07/26/create-smaller-delphi-xe-executables-remove-rtti-pack-exe.htm >> >> Cheers, >> Colin >> >> On 23 August 2012 13:41, Robo <[email protected]> wrote: >> > If I compile the attached project in Delphi XE2, which only contains a >> > blank form, I get a 7MB exe. >> > >> > If I start using DevExpress components, what used to be a 5MB exe in >> > Delphi 2005 turns into a 25MB exe in XE2. >> > >> > - What can I do to reduce the size? The blank project would have been >> > about 500KB in previous versions of Delphi. >> > - How can I keep the file size down when using DevExpress components? >> > >> > _______________________________________________ >> > NZ Borland Developers Group - Delphi mailing list >> > Post: [email protected] >> > Admin: http://delphi.org.nz/mailman/listinfo/delphi >> > Unsubscribe: send an email to [email protected] with >> > Subject: unsubscribe >> _______________________________________________ >> NZ Borland Developers Group - Delphi mailing list >> Post: [email protected] >> Admin: http://delphi.org.nz/mailman/listinfo/delphi >> Unsubscribe: send an email to [email protected] with >> Subject: unsubscribe > > > > _______________________________________________ > NZ Borland Developers Group - Delphi mailing list > Post: [email protected] > Admin: http://delphi.org.nz/mailman/listinfo/delphi > Unsubscribe: send an email to [email protected] with > Subject: unsubscribe _______________________________________________ NZ Borland Developers Group - Delphi mailing list Post: [email protected] Admin: http://delphi.org.nz/mailman/listinfo/delphi Unsubscribe: send an email to [email protected] with Subject: unsubscribe
