Hi Mike, I found no trouble using the esp32-devkitc:blewifi configuration. May I ask you to double-check your bootloader/partition-table configuration? (you can refer to https://nuttx.apache.org/docs/latest/platforms/xtensa/esp32/index.html#bootloader-and-partitions ).
If not successful yet, please do the following: Select the esp32-devkitc:nxdiag configuration and run the `nxdiag -all` from the NSH (please refer to https://nuttx.apache.org/docs/latest/platforms/xtensa/esp32/boards/esp32-devkitc/index.html#nxdiag). Please share your results for reevaluattion ;) Best regards, Em ter., 29 de ago. de 2023 às 18:03, Tiago Medicci Serrano < tiago.medi...@gmail.com> escreveu: > Hi, > > I'll take a look at it soon. Interestingly, our internal CI tests all the > defconfigs, so I wouldn't expect any erroneous behavior. > > I'll check. > > Best regards, > > Em ter., 29 de ago. de 2023 às 16:38, Mike Moretti > <nu...@mordent.com.invalid> escreveu: > >> Hi, >> >> I'm using NuttX 12.2.1 on an esp32 wroom devkit. >> >> If I try to configure NuttX via tools/configure.sh using the >> esp32-devkitc:blewifi configuration, when I boot the esp32, I get problems >> with it telling me there's no bootable app. >> >> If I instead start with the esp32-devkitc:nsh configuration and add wifi >> and ble to it via menuconfig, I get only a little further. It gets past >> the entropy message and then I see "AB" and it hangs forever. With all the >> ble options disabled and only wifi configured by itself it actually boots >> into nsh after some time. (At first, I had a somewhat similar issue with >> nsh when wifi only is enabled and connection info wasn't defined in the >> config file, where it would seem to hang and then finally show a prompt. >> It wasn't until I actually figured out about turning on CONFIG_DEBUG >> "ERROR" for network/wireless that it showed me a bunch of errors during >> boot and I knew it wasn't just hanging permanently and to just wait for it >> a bit to show an nsh prompt.) >> >> However, there don't seem to be any config debug options for bluetooth. >> I have no idea why it hangs as no messages are displayed and it never shows >> a prompt even after a half an hour. I've now spent hours messing with >> various BLE configuration options with no luck. I'm including my config >> file in hope that someone might see something wrong with it. >> >> Thanks, >> -m >> -- >> Mike Moretti >> ♩♫♫♩♪♩ >> > > > -- > Tiago Medicci Serrano > > Embedded Software Engineer > MSc Electronics/Microelectronics > m: +55 (19) 981403886 <+55+(19)+981403886> > e: tiago.medi...@gmail.com > a: Campinas, Brazil > Follow me: > <https://www.linkedin.com/in/tiago-serrano-924458b6> > <https://github.com/tmedicci> > -- Tiago Medicci Serrano Embedded Software Engineer MSc Electronics/Microelectronics m: +55 (19) 981403886 <+55+(19)+981403886> e: tiago.medi...@gmail.com a: Campinas, Brazil Follow me: <https://www.linkedin.com/in/tiago-serrano-924458b6> <https://github.com/tmedicci>
