From: Justin Pettit <[email protected]>
The proper way to switch the networking back-end is to use the
"xe-switch-network-stack" command rather than directly modifying
"/etc/xensource/network.conf". Use that method in the spec file.
---
xenserver/openvswitch-xen.spec | 14 ++------------
1 files changed, 2 insertions(+), 12 deletions(-)
diff --git a/xenserver/openvswitch-xen.spec b/xenserver/openvswitch-xen.spec
index 97bf99c..de702ad 100644
--- a/xenserver/openvswitch-xen.spec
+++ b/xenserver/openvswitch-xen.spec
@@ -226,12 +226,7 @@ done
if [ "$1" = "1" ]; then # $1 = 2 for upgrade
# Configure system to use Open vSwitch
- echo vswitch > /etc/xensource/network.conf
-
- printf "\nYou MUST reboot the server NOW to complete the change to\n"
- printf "Open vSwitch. Attempts to modify networking on the server\n"
- printf "or any hosted VM will fail until after the reboot and could\n"
- printf "leave the server in a state requiring manual recovery.\n\n"
+ xe-switch-network-backend vswitch
else
mode=$(cat /etc/xensource/network.conf)
@@ -310,12 +305,7 @@ if [ "$1" = "0" ]; then # $1 = 1 for upgrade
rmdir -p /usr/lib/openvswitch/xs-saved 2>/dev/null
# Configure system to use bridge
- echo bridge > /etc/xensource/network.conf
-
- printf "\nYou MUST reboot the server now to complete the change to\n"
- printf "standard Xen networking. Attempts to modify networking on the\n"
- printf "server or any hosted VM will fail until after the reboot and\n"
- printf "could leave the server in a state requiring manual recovery.\n\n"
+ xe-switch-network-backend bridge
fi
%files
--
1.7.4.4
_______________________________________________
dev mailing list
[email protected]
http://openvswitch.org/mailman/listinfo/dev
