On Thu, Jul 28, 2016 at 11:26:17PM -0700, Justin Pettit wrote:
> This commit only supports static MAC bindings. A future commit will add
> support for dynamic IPv6/MAC bindings. It has a few other limitations
> described in "ovn/TODO".
>
> Signed-off-by: Justin Pettit <[email protected]>
Missing space after ")." below:
> + <code>icmp6.type == 128 && icmp6.code == 0</code>
> + (ICMPv6 echo request).The port of the router that receives the
Let's put ip.ttl in <code></code>:
> + echo request does not matter. Also, the ip.ttl of the echo
> + request packet is not checked, so it complies with RFC 1812,
> + section 4.2.2.9. Flows for ICMPv4 echo requests use the
> + following actions:
> </p>
The \"\" below should be just "":
> +nd_na {
> + eth.src = <var>E</var>;
> + ip6.src = <var>A</var>;
> + nd.target = <var>A</var>;
> + nd.tll = <var>E</var>;
> + outport = inport;
> + inport = \"\"; /* Allow sending out inport. */
> + output;
> +};
op_put_v6_networks() doesn't, strictly speaking, need the special case
for a single IP address; it's perfectly fine to put a single IP address
in {}.
Acked-by: Ben Pfaff <[email protected]>
_______________________________________________
dev mailing list
[email protected]
http://openvswitch.org/mailman/listinfo/dev
