Exactly this is why I gave a +1 and confirmed the three suggested naming
conventions.
Just listed additionally all publicly known Modbus related protocols so
that everyone in the community is on the same page :-)

Am Mi., 9. März 2022 um 17:07 Uhr schrieb Christofer Dutz <
[email protected]>:

> Hi Lukas,
>
> I think that Modbus+ is a completely different thing. Seems to be related
> to routing of Modbus traffic ... haven't looked too deep at it.
>
> From the Spec side there are 3 variants:
> - Modbus TCP
> - Modbus RTU
> - Modbus ASCII
>
> In general Modbus RTU and ASCII are sort of the same (Serial) ... the main
> difference is the encoding of the payload and the termination of frames.
> That's why I'll leave the ModbusSerialAdu as topmost packet in both Modbus
> RTU and ASCII, as the difference is handled on the level between the
> transport and the driver.
>
> Please correct me if I'm wrong,
>
> Chris
>
> -----Original Message-----
> From: Lukas Ott <[email protected]>
> Sent: Mittwoch, 9. März 2022 16:48
> To: [email protected]
> Subject: Re: [DISCUSS] Rename "modbus" to "modbus-tcp"?
>
> +1
>
> I would follow the most common naming convention and call the drivers the
> following:
> - Modbus ASCII
>       - Supported Devices: Any Device Supporting Modbus ASII, Any Modbus
> ASCII Comliant PLC, Flow Computers
> - Modbus TCP/ IP (What is Modbus TCP/IP ? | Modbus Tcp/ip vs Ethernet ip -
> The Automization <https://theautomization.com/what-is-modbus-tcp-ip/>)
>     - Supported Devices: Applicom: Generic Modbus, TSX Premium, TSX
> Quantum, Fluenta FGM, Instromet, Mailbox, Modbus Ethernet, Roxar RFM
> - Modbus Plus (Difference between Modbus & Modbus Plus | Instrumentation
> and Control Engineering (automationforum.co) <
> https://automationforum.co/difference-between-modbus-modbus-plus/> )
>       - Supported Devices: AT-984 Programmable Controller Board, Hilscher
> CIF Card, Modbus Plus ISA PC Adapter Card, Modbus Plus PCI PC Adapter Card,
> Modbus Plus Type II PCMCIA Card, Modbus Plus Type III PCMCIA Card, Modbus
> Plus Type III PnP PCMCIA Card, SA85 (-002 and -001) PC Interface Cards,
> SA85-PCI
> - Modbus Serial
>     - Supported Devices: Daniel S500 Flow Computer, Dynamic Fluid Meter,
> Elliot Flow Computer, Magnetek GPD 515 Drive, Modbus Compatible Devices,
> Omni Flow Computer (Enron Modbus), TSXCUSBMBP USB Adapter
> - Modbus RTU Server Serial
>     - Any Modbus compatible devices
>
> Modbus ASCII vs Modbus RTU vs Modbus TCP/IP - The Automization <
> https://theautomization.com/modbus-ascii-vs-modbus-rtu-vs-modbus-tcpip/>
>
> To sum up, basically following your suggestion: modbus-tcp, modbus-rtu and
> modbus-ascii sounds like a good approach.
>
> Cheers,
> otluk
>
>
>
> Am Mi., 9. März 2022 um 15:19 Uhr schrieb Christofer Dutz <
> [email protected]>:
>
> > Hi all,
> >
> > I'm currently working on the modbus RTU stuff ... as in general the
> > protocols are referred to modbus-tcp, modbus-rtu und modbus-ascii, I
> > would like to rename the "modbus" to "modbus-tcp" ... While modbus-tcp
> > will not be many variants, will the modbus-rtu and ascii also be
> > available as "modbus-rtu:tcp" if a tcp tunnel is used.
> >
> > What do you think?
> >
> > Chris
> >
>

Reply via email to