Thanks for the help Eshan but actually I have already performed this step (sudo apt-get build-dep build-essential gcc-defaults g++ gdb git \ unzip pax bison flex texinfo unzip python3-dev libpython-dev \ libncurses5-dev zlib1g-dev) , here since my system was not able to find libpython-dev (Unable to find a source package for libpython-dev ) so i used libpython2.7-dev , I tried with both python2-dev and python3-dev ( sudo apt-get build-dep build-essential gcc-defaults g++ gdb git \ unzip pax bison flex texinfo unzip python2-dev libpython2.7-dev \ libncurses5-dev zlib1g-dev Reading package lists... Done Picking 'gcc-defaults' as source package instead of 'g++' Picking 'python-defaults' as source package instead of 'python2-dev' Picking 'python2.7' as source package instead of 'libpython2.7-dev' Picking 'ncurses' as source package instead of 'libncurses5-dev' Picking 'zlib' as source package instead of 'zlib1g-dev' Reading package lists... Done Building dependency tree Reading state information... Done 0 upgraded, 0 newly installed, 0 to remove and 184 not upgraded. ) , but then also same Build FAILED error comes up (configure: error: pax is missing) . Also I wanted to know does the rsb in rtems6 uses autoconf-based build system , since there is no configure file made and used.
On Wed, Feb 10, 2021 at 1:04 AM Eshan Dhawan <eshandhawa...@gmail.com> wrote: > > Hi ayushman > It looks you didn't install all the dependencies required > check this : > https://docs.rtems.org/branches/master/user/hosts/posix.html#linux > > On Wed, Feb 10, 2021 at 12:58 AM Ayushman Mishra <ayushvidush...@gmail.com> > wrote: >> >> Ayusman Mishra >> 1. I was going through ticket #4145 >> (https://devel.rtems.org/ticket/4145) and tried building bsp on rtems6 >> and rtems5 both using rsb >> (https://docs.rtems.org/branches/master/user/start/bsp-build.html#rsb-bsp-build) >> but got Build FAILED (it says pax is missing (configure: error: pax is >> missing.), I have attached full error report txt file). However I did >> build bsp erc32 and pc386 using rsb on rtems5 (first .bootstrap -c >> sb-bootstrap then used configure file >> ($HOME/development/rtems/rtems-5/configure --target=i386-rtems5 >> --enable-rtemsbsp=pc386 )) on rtems6 there is no sb-bootstrap file or >> configure file present/made. >> I wanted to know is there anyway of using RSB on rtems6. >> Also while building different bsp toolsets for rtems (erc32/pc386) I >> used rtems on 2 different directories , Is there any way of building >> different BSPs on same rtems? >> >> 2. I went through list of open projects and found projects related to >> testing and development of ecosystem quite interesting, >> #3710 https://devel.rtems.org/ticket/3710 >> #3860 https://devel.rtems.org/ticket/3860 >> #3892 https://devel.rtems.org/ticket/3892 >> I would be very grateful to know if any of the above projects is open >> for participation and if yes then work done/needed to be done in it. >> _______________________________________________ >> devel mailing list >> devel@rtems.org >> http://lists.rtems.org/mailman/listinfo/devel > > > > -- > Thanks > - Eshan _______________________________________________ devel mailing list devel@rtems.org http://lists.rtems.org/mailman/listinfo/devel
