yes, all changes to release branches need a ticket
On Wed, Mar 3, 2021 at 12:35 PM Gedare Bloom <[email protected]> wrote: > > I think you can also remove beatnik/net/if_mve/testing.c? > > On Wed, Mar 3, 2021 at 11:13 AM Vijay Kumar Banerjee <[email protected]> wrote: > > > > --- > > .../beatnik/net/if_mve/mve_smallbuf_tst.c | 145 ------------------ > > .../beatnik/net/porting/if_xxx.modini.c | 34 ---- > > 2 files changed, 179 deletions(-) > > delete mode 100644 bsps/powerpc/beatnik/net/if_mve/mve_smallbuf_tst.c > > delete mode 100644 bsps/powerpc/beatnik/net/porting/if_xxx.modini.c > > > > diff --git a/bsps/powerpc/beatnik/net/if_mve/mve_smallbuf_tst.c > > b/bsps/powerpc/beatnik/net/if_mve/mve_smallbuf_tst.c > > deleted file mode 100644 > > index 721ade30d1..0000000000 > > --- a/bsps/powerpc/beatnik/net/if_mve/mve_smallbuf_tst.c > > +++ /dev/null > > @@ -1,145 +0,0 @@ > > -#include <rtems.h> > > -#include <bsp.h> > > -#include <bsp/if_mve_pub.h> > > -#include <stdlib.h> > > -#include <stdio.h> > > - > > -/* Demo for the mv64360 ethernet quirk: > > - * > > - * $$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$ > > - * $$ buffer segments < 8 bytes must be aligned $$ > > - * $$ to 8 bytes but larger segments are not $$ > > - * $$ sensitive to alignment. $$ > > - * $$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$ > > - * > > - * How to use: > > - * > > - * Init MVE driver on (unused) unit 2: > > - * > > - * mve = mvtst_init(2) > > - * > > - * data = { 1,2,3,4,5,6,7,8,9,0xa,0xb, ... } > > - * > > - * Alloc 2-element mbuf chain (1st holds an > > - * ethernet header which is > 8bytes so we can't > > - * test this with only 1 mbuf. The 2nd mbuf holds > > - * a small fragment of data). > > - * > > - * mb = mvtst_getbuf(mve) > > - * > > - * Copy data into aligned area inside 2nd mbuf, > > - * (so that you can see if the chip starts using > > - * the aligned area rather than the unaligned > > - * buffer pointer). Point mbuf's data pointer > > - * at 'off'set from the aligned area: > > - * > > - * mvtst_putbuf(mb, data, len, offset) > > - * > > - * Send chain off: > > - * > > - * BSP_mve_send_buf(mve, mb, 0, 0) > > - * > > - * Watch raw data: > > - * > > - * tcpdump -XX -vv -s0 ether host <my-ether-addr> > > - * > > - * E.g, if offset = 1, len = 2 then we would like > > - * to see > > - * > > - * GOOD: > > - * < 14 header bytes > 0x02, 0x03 > > - > > - * but if the chip starts DMA at aligned address > > - * we see instead > > - * BAD: > > - * < 14 header bytes > 0x01, 0x02 > > - */ > > - > > -static inline void *rmalloc(size_t l) { return malloc(l); } > > -static inline void rfree(void *p) { return free(p); } > > - > > -#define _KERNEL > > -#include <sys/param.h> > > -#include <sys/mbuf.h> > > - > > -static void > > -cleanup_buf(void *u_b, void *closure, int error) > > -{ > > -rtems_bsdnet_semaphore_obtain(); > > - m_freem((struct mbuf*)u_b); > > -rtems_bsdnet_semaphore_release(); > > -} > > - > > -struct mbuf *mvtst_getbuf(struct mveth_private *mp) > > -{ > > -struct mbuf *m,*n; > > - > > - if ( !mp ) { > > - printf("need driver ptr arg\n"); > > - return 0; > > - } > > -rtems_bsdnet_semaphore_obtain(); > > - MGETHDR(m, M_DONTWAIT, MT_DATA); > > - MGET(n, M_DONTWAIT, MT_DATA); > > - m->m_next = n; > > -rtems_bsdnet_semaphore_release(); > > - /* Ethernet header */ > > - memset( mtod(m, unsigned char*), 0xff, 6); > > - BSP_mve_read_eaddr(mp, mtod(m, unsigned char*) + 6); > > - /* Arbitrary; setting to IP but we don't bother > > - * to setup a real IP header. We just watch the > > - * raw packet contents... > > - */ > > - mtod(m, unsigned char*)[12] = 0x08; > > - mtod(m, unsigned char*)[13] = 0x00; > > - m->m_pkthdr.len = m->m_len = 14; > > - n->m_len = 0; > > - return m; > > -} > > - > > -int > > -mvtst_putbuf(struct mbuf *m, void *data, int len, int off) > > -{ > > -int i; > > - if ( m ) { > > - m->m_pkthdr.len += len; > > - if ( ( m= m->m_next ) ) { > > - m->m_len = len; > > - memcpy(mtod(m, void*), data, 32); > > - m->m_data += off; > > - printf("m.dat: 0x%08x, m.data: 0x%08x\n", m->m_dat, > > m->m_data); > > - for ( i=0; i< 16; i++ ) { > > - printf(" %02x,",mtod(m, unsigned char*)[i]); > > - } > > - printf("\n"); > > - } > > - } > > - > > - return 0; > > -} > > - > > -static void *alloc_rxbuf(int *p_size, unsigned long *paddr) > > -{ > > - return *(void**)paddr = rmalloc((*p_size = 1800)); > > -} > > - > > -static void consume_buf(void *buf, void *closure, int len) > > -{ > > - rfree(buf); > > -} > > - > > -void * > > -mvtst_init(int unit) > > -{ > > -struct mveth_private *mp; > > - mp = BSP_mve_setup( > > - unit, 0, > > - cleanup_buf, 0, > > - alloc_rxbuf, > > - consume_buf, 0, > > - 10, 10, > > - 0); > > - if ( mp ) > > - BSP_mve_init_hw(mp, 0, 0); > > - return mp; > > -} > > diff --git a/bsps/powerpc/beatnik/net/porting/if_xxx.modini.c > > b/bsps/powerpc/beatnik/net/porting/if_xxx.modini.c > > deleted file mode 100644 > > index 1abad7dc22..0000000000 > > --- a/bsps/powerpc/beatnik/net/porting/if_xxx.modini.c > > +++ /dev/null > > @@ -1,34 +0,0 @@ > > -#include <rtems.h> > > -#include <porting/rtemscompat.h> > > - > > -/* CEXP module initialization/finalization */ > > - > > -/* Copyright: Till Straumann <[email protected]>, 2005; > > - * License: see LICENSE file. > > - */ > > - > > -void > > -_cexpModuleInitialize(void *unused) > > -{ > > -extern void NET_EMBEMB(rtems_,NETDRIVER_PREFIX,_bringup)(char *); > > - METHODSPTR = &METHODS; > > -/* > > -#ifdef DEBUG > > - > > NET_EMBEMB(rtems_,NETDRIVER_PREFIX,_bringup)("192.168.2.13/255.255.255.0"); > > -#endif > > -*/ > > -} > > - > > -int > > -_cexpModuleFinalize(void *unused) > > -{ > > -#ifdef DEBUG > > -extern int NET_EMBEMB(rtems_,NETDRIVER_PREFIX,_bringdown)(); > > - if (NET_EMBEMB(rtems_,NETDRIVER_PREFIX,_bringdown)()) > > - return -1; > > - METHODSPTR = 0; > > - return 0; > > -#else > > - return -1; > > -#endif > > -} > > -- > > 2.26.2 > > > > _______________________________________________ > > devel mailing list > > [email protected] > > http://lists.rtems.org/mailman/listinfo/devel _______________________________________________ devel mailing list [email protected] http://lists.rtems.org/mailman/listinfo/devel
