> I was following this General discussion thread: > > http://www.e-smith.org/bboard//read.php?f=1&i=8744&t=8744 > > which talks about parameters you can add at boot/install time. There is > a parameter that will prompt the installer to ask for a driver disk at > install time. Where you are initially prompted to enter 'accept', simply > enter 'accept dd'. I've tested and can confirm this prompts the > installer to ask for a driver disk :) > > I do not have any non-standard hardware to test this any further. Any > volunteers?
I've tested that solution to get a ide ata 100 raid card (hpt370) working on e-smith. It's OK with e-smith 4.1x coz highpoint provides drivers for redhat 7.0 & 7.1. But because of its kernel I can't install sme v5 with redhat 7.1 drivers. Highpoint didn't answer my mails asking module sources ou appropriate version ... Should I stay (4.1) or should I go (redhat :( ) ?? Please excuse my poor english once again. -- Please report bugs to [EMAIL PROTECTED] Please mail [EMAIL PROTECTED] (only) to discuss security issues Support for registered customers and partners to [EMAIL PROTECTED] To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] Archives by mail and http://www.mail-archive.com/devinfo%40lists.e-smith.org
