HI all,
I have followed as per the instructions given in the webpage for set up of
the Usrp N200/N210 but still i am unable to communicate between the
hardware and host pc
1.I have set the static ip of the host pc to
192.168.10.1(ifconfig eth0 192.168.10.1).
2.Whenever i give the device address=addr=192.168.10.1 and run the grc i am
getting the error has “*unknown key format*”
3.Whenever i ping 192.168.10.2 or use the command uhb_find_device i am
getting warning as “*NO DEVICE FOUND* “
4. Is that a must i have to upload the fpga and firmware images when using
the device for the first time.
5.Sometimes i am getting an error like”* unable to find as single device”.*
*6.*The* *host pc is supporting only 10/100MBPS .Is that the only problem
so that i am unable to communicate with the hardware.
Can anybody help me on this issue.Awaiting for your valuable reply
Thanks in advance
Sandhya.G
_______________________________________________
Discuss-gnuradio mailing list
[email protected]
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
