Thanks for the reply. Well is that only problem so that i'm unable to communicate and should i need to update the firmware?
Thanks and regards Sandhya.G On Mon, Oct 21, 2013 at 10:19 AM, Activecat <[email protected]> wrote: > Your pc must have 1000Mbps port. The 10/100Mbps won't work. > An alternative is to connect a 10/100/1000 LAN switch between your pc and > the USRP. > > Rgds, > activecat. > > > On Mon, Oct 21, 2013 at 12:37 PM, Sandhya G <[email protected]> wrote: > >> HI all, >> >> >> I have followed as per the instructions given in the webpage for set up >> of the Usrp N200/N210 but still i am unable to communicate between the >> hardware and host pc >> >> >> >> 1.I have set the static ip of the host pc to >> 192.168.10.1(ifconfig eth0 192.168.10.1). >> >> 2.Whenever i give the device address=addr=192.168.10.1 and run the grc i >> am getting the error has “*unknown key format*” >> >> 3.Whenever i ping 192.168.10.2 or use the command uhb_find_device i am >> getting warning as “*NO DEVICE FOUND* “ >> >> 4. Is that a must i have to upload the fpga and firmware images when >> using the device for the first time. >> >> 5.Sometimes i am getting an error like”* unable to find as single >> device”.* >> >> *6.*The* *host pc is supporting only 10/100MBPS .Is that the only >> problem so that i am unable to communicate with the hardware. >> >> >> >> Can anybody help me on this issue.Awaiting for your valuable reply >> >> >> Thanks in advance >> >> Sandhya.G >> >> _______________________________________________ >> Discuss-gnuradio mailing list >> [email protected] >> https://lists.gnu.org/mailman/listinfo/discuss-gnuradio >> >> >
_______________________________________________ Discuss-gnuradio mailing list [email protected] https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
