MrSinatra;612640 Wrote: > hi, > > can a net-udap expert here have a look at this thread: > > http://forums.slimdevices.com/showthread.php?t=85793 > > ...esp my last post and tell me what more my screenshot needs me to set > properly in the SBR so it will PERMANENTLY remain reachable by the SBS? > > thx!
Not an expert, but can share my experience setting up our SBRs. I have managed to use the Net UDAP tool on our Linux systems, though with some difficulty. I found that it is necessary to be very careful to always make sure that any changes to the config are both: (i) transmitted to the SBR, and, I think, (ii) some kind of save/reset command has to be issued. The procedure is on the NET UDAP webpage but I got confused a few times. I have the impression that just putting things into NET UDAP, isn't enough, an extra step is needed to make sure they are remembered in the SBR. And, to check, you must make sure that the tool tells you what is in the SBR, not what might still be in NET UDAP's memory; I'm not sure what I did to force NET UDAP to forget the settings and re-retrieve them from the SBR, but that was necessary before I could be sure the SBR was set up correctly. I did it again, after switching the SBR off and back on, as well. I did manage, from advice on the thread, and on the NET UDAP webpage. (I'll comment separately on your other thread, about an IP issue you could also be having.) regards, Atlantic -- Atlantic ------------------------------------------------------------------------ Atlantic's Profile: http://forums.slimdevices.com/member.php?userid=44239 View this thread: http://forums.slimdevices.com/showthread.php?t=57861 _______________________________________________ discuss mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/discuss
