JohnSwenson wrote: > OK, > what I'll do is put a 24pin .5mm FFC connector on the board with I2S, > MCLK, MCLK in, a frequency family selection signal (chooses between > 22.5792 and 24.576) and a signal to specify if you are feeding an MCLK > into the board. The pinout is going to be the same as the ABC boards. > The connector is going to be in the isolated domain. > > I will send out the raw I2S (not reclocked), if you need to reclock do > that on your board as close to the DAC chip as possible. I will not > provide specific sample rate info, just the family selection. If you > need to determine the actual sample rate you can do that by analyzing > the I2S signal. The MCLK coming out will be either 22.5792 or 24.576, if > you are supplying your own MCLK you must use one of those frequencies. > You must be prepared to alter the polarity of the clock, I cannot > guarantee the timing of the I2S signals will be appropriate for all > reclockers, you must be prepared to change the polarity sent to the > board to compensate for this. > > John S.
John, this is more than I could have hoped for. I am very excited to obtain your board. Will these signals be single ended or differential? Jack ------------------------------------------------------------------------ JIJ3's Profile: http://forums.slimdevices.com/member.php?userid=36534 View this thread: http://forums.slimdevices.com/showthread.php?t=97881 _______________________________________________ discuss mailing list discuss@lists.slimdevices.com http://lists.slimdevices.com/mailman/listinfo/discuss
