Ok, this is resolved. I could not get the two networks connected via bridging. I had to set the "remote" wireless device up as a Client Wireless Router. Once I did that, and gave a wired client at the remote site an appropriate IP address, I was able to span the air gap between the two networks.
Not sure why I couldn't get it to work as a bridge, but my ultimate goal was to get packets flowing, and that has been accomplished. --- Dave L <[EMAIL PROTECTED]> wrote: > I would like to get broadband access to a remote > site. > It's within about a mile (with good line of site) of > the location that will provide the Internet link. > > I thought I could use two of these devices (with > yagi > or dish antennas). > http://www.keenansystems.com/senao_engenius_nl-2611cb5_plus_ext.htm > > It's not working out so well. When I have both > devices > in bridge mode they do not associate. > > Then I set up one as an access point with the other > as > a client bridge, associated with the AP. I plugged a > computer into the same hub as the bridge and the > bridge does not forward packets across the wireless > link. > > Am I out to lunch on how to use wireless to bridge > these two sites? > > > > ____________________________________________________________________________________ > Looking for last minute shopping deals? > Find them fast with Yahoo! Search. > http://tools.search.yahoo.com/newsearch/category.php?category=shopping > ____________________________________________________________________________________ Be a better friend, newshound, and know-it-all with Yahoo! Mobile. Try it now. http://mobile.yahoo.com/;_ylt=Ahu06i62sR8HDtDypao8Wcj9tAcJ _______________________________________________ SoCalFreeNet.org General Discussion List To unsubscribe, please visit: http://socalfreenet.org/mailman/listinfo/discuss_socalfreenet.org
