I agree that issuing the halt command is easy enough, but in a setup
that's already using sbpd a script wouldn't be necessary. Isn't it just
a case of adding a new command to sbpd_command.cfg, say:
Code:
--------------------
XLMS=["stopserver"]
--------------------
...and then assigning that command to a GPIO button press? Since
'stopserver' is an LMS command I'm assuming this stops LMS only, leaving
pCP running, but since LMS is apparently the only process that might
corrupt the SD card, it should then be safe to pull the power.
------------------------------------------------------------------------
chill's Profile: http://forums.slimdevices.com/member.php?userid=10839
View this thread: http://forums.slimdevices.com/showthread.php?t=107001
_______________________________________________
diy mailing list
[email protected]
http://lists.slimdevices.com/mailman/listinfo/diy
