meq123 wrote: > You don't need a Vcc pin. If they're like most other encoders, connect > the center one of the three pins to ground and the other two as the > up/down pins (reverse them if they go the wrong way when you turn the > knob). The twp pins on the other side will be the push switch. Connect > one of them to ground and the other to the gpio pin you are using for > the push function - doesn't matter which of the two pins goes to ground > and which goes to gpio.
Thank you for your answer! Is there some specific GPIO pins that I should use? How do I know if the GPIO pin has internal pull-up resistor in use for example? Thanks! -Jursi ------------------------------------------------------------------------ Jursi's Profile: http://forums.slimdevices.com/member.php?userid=69100 View this thread: http://forums.slimdevices.com/showthread.php?t=107001 _______________________________________________ diy mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/diy
