"Greg" <[EMAIL PROTECTED]> made an utterance to the drakelist gang
----------------------------------------------------------------------
I had the same problem on my R4C, I changed the ball-bearing and there's an
allen screw you can adjust, I had to tighten it very slightly.
This shows the location:
http://www.wb4hfn.com/DRAKE/DrakeArticles/TechTips/PTO-Repair.htm
//Greg
Keith Hamilton <[EMAIL PROTECTED]> made an utterance to the drakelist gang
----------------------------------------------------------------------
I have an R-4C receiver with metal gears in the PTO
assembly. I have too much free play in the PTO
assembly. The knob can move up and down at least an
1/8 of an inch (maybe more) There is no free play in
and out. I need some sugestions about where to adjust
the gear train or bearings to eliminate the up and
down play.
The PTO bearings had been heavily greased and it took
a lot of work to clean out the grease and loosen up
the PTO. I lightly oiled only the bearings and it now
turns freely like it should, but I would like to
eliminate the annoying free play. (it had the free
play problem before I "ungreased" it.)
73 Keith, N8QO
----------------------------------------------------------------------
Submissions: [email protected]
Unsubscribe: [EMAIL PROTECTED] - unsubscribe drakelist in body
Hopelessly Lost: [EMAIL PROTECTED] - help in body of message
Zerobeat Web Page: www.zerobeat.net - sponsored by www.tlchost.net
----------------------------------------------------------------------
