Garey Barrell <[EMAIL PROTECTED]> made an utterance to the drakelist gang
----------------------------------------------------------------------
Al -
Sounds good for an unloaded supply.
73, Garey - K4OAH
Atlanta
Drake B & C-Line Service CDs
<http://www.k4oah.com>
n7ioh wrote:
n7ioh <[EMAIL PROTECTED]> made an utterance to the drakelist gang
----------------------------------------------------------------------
Hi all, I just installed my 120-240 VAC switch in my
AC-4 and replaced R3 with a 100 ohm 10 watt resistor
(was burnt). I wanted to be sure I did not have any
problems so I checked the voltages to be sure. I
think all is OK but thought it wiser to ask those of
you with more experience then me if all is well. I
just finished checking the voltages as described by
Mark Gilger WB0IQK in his AC-4 Trouble Shooting
article. I did the test as he described but was
wondering if my voltages are close enough or typical
of a no load voltage readings at the AC-4 plug. My
input voltage is 120VAC, the +650VDC reading is
715VDC, the +250VDC reading is 292VDC, my bias
adjusted fine and my filament voltage was 13.86VAC.
Thanks, Al, n7ioh
----------------------------------------------------------------------
Submissions: [email protected]
Unsubscribe: [EMAIL PROTECTED] - unsubscribe drakelist in body
Hopelessly Lost: [EMAIL PROTECTED] - help in body of message
Zerobeat Web Page: www.zerobeat.net - sponsored by www.tlchost.net
----------------------------------------------------------------------
