Enable MDSS, DSI0, and its PHY. Attach the SW43103 panel with its power
rails, enable and reset GPIOs, and four-lane DSI link.

Signed-off-by: Abdur Rofik <[email protected]>
---
 arch/arm64/boot/dts/qcom/sm8250-lg-timelm.dts | 36 +++++++++++++++++++
 1 file changed, 36 insertions(+)

diff --git a/arch/arm64/boot/dts/qcom/sm8250-lg-timelm.dts 
b/arch/arm64/boot/dts/qcom/sm8250-lg-timelm.dts
index 00e3fa560e95e..59d6c1518a469 100644
--- a/arch/arm64/boot/dts/qcom/sm8250-lg-timelm.dts
+++ b/arch/arm64/boot/dts/qcom/sm8250-lg-timelm.dts
@@ -461,6 +461,42 @@ &gpu_zap_shader {
        firmware-name = "qcom/sm8250/LG/timelm/a650_zap.mbn";
 };
 
+&mdss {
+       status = "okay";
+};
+
+&mdss_dsi0 {
+       vdda-supply = <&vreg_l9a_1p2>;
+       status = "okay";
+
+       panel@0 {
+               compatible = "lg,sw43103";
+               reg = <0>;
+
+               vddi-supply = <&vreg_l14a_1p8>;
+               vpnl-supply = <&vreg_l11c_3p0>;
+
+               reset-gpios = <&tlmm 75 GPIO_ACTIVE_LOW>;
+               enable-gpios = <&pm8150l_gpios 4 GPIO_ACTIVE_HIGH>;
+
+               port {
+                       panel_in: endpoint {
+                               remote-endpoint = <&mdss_dsi0_out>;
+                       };
+               };
+       };
+};
+
+&mdss_dsi0_out {
+       remote-endpoint = <&panel_in>;
+       data-lanes = <0 1 2 3>;
+};
+
+&mdss_dsi0_phy {
+       vdds-supply = <&vreg_l5a_0p88>;
+       status = "okay";
+};
+
 &pm8150_gpios {
        google_assist_state: google-assist-state {
                pins = "gpio1";
-- 
2.39.5

Reply via email to