Chaz, I cannot reproduce point 2.
I have a dual monitor setup and the country reappears in the same spot when I reopen DX4WIN. I enabled: Preferences | Screen | Leave all windows in original position --Paul At 09:16 PM 6/8/2006, you wrote: >DX4Win-ers: > >I thought I'd pass these along so others might not redundantly send them in. > >These are observed and easily reproduced in 7.02; they were present in 6.x as >well. > >1) Preferences/Ext Data > >If you use "Website callsign lookup" you must put something in both the >"Callsign lookup address" field AND the "QSL manager lookup address" field. >If you don't, pressing F3, Enter from the QSO window does nothing. > >Here's the way this is supposed to work (according to the User Guide) : > >If the field with focus in the QSO window is ANYTHING OTHER THAN the QSL >manager field, pressing F3 followed by Enter is supposed to do a callsign >lookup on the website you chose in the Preferences/Ext Data/Callsign lookup >address box. > >If the field with focus in the QSO window IS QSL manager, pressing F3 followed >by Enter is supposed to do a QSL manager lookup on the website you chose in >Preferences/Ext Data/QSL manager lookup address. > >It doesn't work that way. > >In my case, I used http://www.qrz.com for the Callsign lookup and >http://www.qrz.com/callsign?qsl= in the QSL manager lookup (as instructed in >both the online help and the User Guide). > >There are two problems: No matter where the field focus is in the QSO window, >pressing F3 and Enter always goes to the QSL manager lookup address. >Paradox: If you only want to do a Callsign lookup, you can never do a Manager >lookup because you must put http://www.qrz.com/ in BOTH the Callsign lookup >box AND the QSL manager lookup box. > >The workaround is to put http://www.qrz.com/ in both the Callsign and QSL >manager lookup boxes. If you do that, at least F3, Enter does the callsign >lookup. > >And, while I'm whining, I asked that the F3 followed by Enter be changed to >just F3. The Enter keypress shouldn't be necessary. > >2. Country Window position (dual monitor setup) > >When you ask that DX4WIN remember window position by Preferences/Screen and >using the "Leave all windows in original position" checkbox, it does not >affect the Country window. No matter where you move it to, when you exit it >comes back to the middle of the left-hand screen (approximately). Note:this >only behaves as described on my dual monitor setup. > >And, while whining, the wording for the checkbox should be "Leave all windows >where they are on exit". > >Just tryin' to help.. > >Chaz, W4GKF > >_______________________________________________ >Dx4win mailing list >[email protected] >http://mailman.qth.net/mailman/listinfo/dx4win ~~~~~~~~~~~~~~~~~~~~~~~~~~~~ Paul van der Eijk (KK4HD) [EMAIL PROTECTED] http://www.dx4win.com
