Hi Tibor, Tried this out a few months ago before the bandmap was in DX4WIN. I used bandmaster from VE3NEA,DX4WiN and HRD to see if the VSPE Driver could handle it, I could make it working but very unstable, Saved configuration did not work correct after shutting down and restarting So everytime I had to reconfigure all, shortly after my tests the developing In dx4win has started......
Guy ON4AOI > -----Oorspronkelijk bericht----- > Van: [email protected] [mailto:dx4win- > [email protected]] Namens Tibor M. Blum - IK2SAI - > Verzonden: zondag 23 augustus 2009 11:56 > Aan: [email protected] > Onderwerp: [Dx4win] A strange thing > > Hy guys. > > My set up is a TS2000X with CAT made via Ham Radio Deluxe. > > Connection Is made with a serial/USB converter @ 57600 > > PC is an AMD Athlon @ 1 GHz, 640 RAM and Win XP sp3 > > > > Of course if I try to connect DX4WIN to my radio, PC says that the com > is > busy. > > If I connect DX4WIN without running Ham Radio Deluxe, all is ok, band > map is > ok, no problem. > > > > Yesterday in a forum someone talked to me about Virtual Serial Ports > Emulator freeware software (VSPE). > > I immediately installed the software and after some minutes I was able > to > create a virtual com where to address Dx4WIN AND HRD. > > Fantastic: when I receive a spot I click on that, it change me the > setting > of the radio, HRD show all the new parameters and in the Dx4WIN I get > the > call in the right place. > > All works ok.BUT: > > Looking at the band map, it flickers: the vertical, qrg line moves from > left > to right and than again right to left. > > The frequency showed on the top of band map start from the right one > and > step by step goes down..down..down to zero.without moving the real QRG > on > the radio. > > On the QSO input window, the same happen in the frequency display. But > even > the mode and the band are changing step by step without sense. > > I tried to set the radio on 18140 SSB, on the band map the frequency > starts > to move down. In the QSO window problem is that the mode changes to CW, > and > so on and even the qrg moves. If I log the "qso" dx4win doesn't get the > real > data but what is displaying at that time. > > > > I have tried to reduce the com speed down to 9600 but nothing has > changed. > > > > So I returned to my old setting.but there is any way to fix the > problem? > > > > HRD + DX4WIN are just the best of the two worlds and being able to run > them > connected to the radio is certainly fantastic. > > > > Tibor, IK2SAI > > > > ______________________________________________________________ > Dx4win mailing list > Home: http://mailman.qth.net/mailman/listinfo/dx4win > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Dx4win mailing list Home: http://mailman.qth.net/mailman/listinfo/dx4win Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
