I am using the M2 rotor. The rotor control works fine in both Dxbase = 2003 ans 2004.
CUL...Stewart -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] = On Behalf Of Len Geraldi Sent: Sunday, April 27, 2003 6:07 PM To: [email protected] Subject: [DXBase] Com Port problems I recently upgraded from 2002 to 2004. The rotor control works fine in=20 2002. When I attempt to rotate the ant in 2004, the program locks up. = I've=20 double/triple checked the setting and they are exactly the same as in = 2002.=20 I have been using com4. I tried writelog using the same com port for = rotor=20 control and it works fine. I tried moving the rotor control to com3..The same problem, it works = fine=20 in 2002 and not in 2004 everything locks up. I have two makes of rotors = one=20 is M2 the other is Yaesu 1000sdx. I have the same problems regardless of = which rotor I attempt to use. Both of them work in 2002, none of them = work=20 in2004 in com4 or com3. I did and redid the DXB drive setup..no luck. When the program locksup I = have to do the Cntrl, Alt, del and get the "DXbase not responding" = message. Anyone have some ideas or suggestions about this problem. Len, K6ANP=20 _______________________________________________ DXBase Reflector - Please visit us on the web at www.dxbase.com - - - - - - - - - - - - - - - - - - - - - - -=20 To UNSUBSCRIBE please visit: = http://mailman.qth.net/mailman/listinfo/dxbase
