Most important information is what card are you using for the ports above com2?
Ron, N5IN ----- Original Message ----- From: "Jack" <[EMAIL PROTECTED]> To: <[email protected]>; "k6anp" <[EMAIL PROTECTED]> Sent: Sunday, April 27, 2003 10:00 PM Subject: Re: [DXBase] Com Port problems > Sounds like comport trouble to me. Please list the following: > > 1. What is each comport being used for? > 2. What other software is running at same time as DXbase? > 3. Do you have a modem installed and if so, what comport is it assigned to? > > This will possibly help diagnose the conflicts. > > Regards, > Courtney > > ----- Original Message ----- > From: "k6anp" <[EMAIL PROTECTED]> > To: <[email protected]> > Sent: Sunday, April 27, 2003 7:38 PM > Subject: [DXBase] Com Port problems > > > > I should have mentioned in my first message the rotor control works fine > in > > COM 1 & 2. However I need one com for the radio, and two coms for two > > rotors. So, I need a minimum of three working com ports. The radio does > the > > same thing as the rotor, only works in com 1 & 2 in DXBase 2004. The radio > > works in all com ports in DXBase2002. > > > > I recently upgraded from 2002 to 2004. The rotor control works fine in > > 2002. When I attempt to rotate the ant in 2004, the program locks up. I've > > double/triple checked the setting and they are exactly the same as in > 2002. > > I have been using com4. I tried writelog using the same com port for rotor > > control and it works fine. > > I tried moving the rotor control to com3..The same problem, it works fine > > in 2002 and not in 2004 everything locks up. I have two makes of rotors > one > > is M2 the other is Yaesu 1000sdx. I have the same problems regardless of > > which rotor I attempt to use. Both of them work in 2002, none of them work > > in2004 in com4 or com3. > > I did and redid the DXB drive setup..no luck. When the program locksup I > > have to do the Cntrl, Alt, del and get the "DXbase not responding" > message. > > > > Anyone have some ideas or suggestions about this problem. > > > > Len, K6ANP > > > > > > > > --- StripMime Report -- processed MIME parts --- > > multipart/alternative > > text/plain (text body -- kept) > > text/html > > The reason this message is shown is because the post was in HTML > > or had an attachment. Attachments are not allowed. To learn how > > to post in Plain-Text go to: http://www.expita.com/nomime.html --- > > _______________________________________________ > > DXBase Reflector - Please visit us on the web at www.dxbase.com > > - - - - - - - - - - - - - - - - - - - - - - - > > To UNSUBSCRIBE please visit: > > http://mailman.qth.net/mailman/listinfo/dxbase > > > > > _______________________________________________ > DXBase Reflector - Please visit us on the web at www.dxbase.com > - - - - - - - - - - - - - - - - - - - - - - - > To UNSUBSCRIBE please visit: > http://mailman.qth.net/mailman/listinfo/dxbase >
